rubber metal bonding adhesive > rubber metal wear resistant repair compound epoxy adhesive

rubber metal wear resistant repair compound epoxy adhesive

BD805 rubber metal wear abrasion resistant bonding repair compound epoxy adhesive

Product description:
1.It is the Two-component adhesive compounded by polyurethane modified epoxy resin and modified amine curing agent
and various auxiliaries.

2.The curing speed is moderate,the highest temperature resistance of the curing product is 100 degree.

3.With the excellent adhesion to metal,rubber and so on.The adhesive layers after curing has excellent shock resistance

4. With the good water resistance,oil resistance,high and low temperature resistance and aging resistance.

5.Especially suitable for the bonding of rubber compound and metal.

product usage of BD805 wear resistant rubber metal bonding repair epoxy compound adhesives:
Used in the self-adhesion and each-adhesion of metal,ceramic,cement,stone,glass,rubber and other materials,
especially suitable for the bonding of strong shock vibration artifacts,when the bonding of metal and ceramic,
can effectively avoid knocking against and ceramic chip falling off which caused by impacting.

performance index of BD805 metal rubber abrasion resistant epoxy adhesive repair bonding compound:

product name	physical state	standard packaging	operation time limit (25℃)	usable time (25℃)	Range of application
BD805 rubber metal bonding epoxy adhesive	paste	12kg	1.5h	12 hours	Used in the self-adhesion and each-adhesion between metal,ceramic and rubber.Such as the bonding of machine tool lathe bed, all kinds of box body,big modulus gear fracture. Especially suitable for the bonding of rubber compound and metal

Item model	color	density (g/cm3)	shear strength (kg/cm2) GB7124-2008	impact strength (J/cm2) GB6328-1999	tensile strength (kg/cm2) GB6329-2008	peel strength （N/cm）	working temperature （℃）
BD805	gray	1.21	256	180	685	12	-60-100

How to use:
1.Surface treatment: Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend.
Clean it by cleaning agent and dry it by airing in the end.

2.Configure adhesive: Make A and B two components mix uniformly according to A:B=2:1,when the temperature is too low,
can put the main agent and curing agent into the temperature of 50℃ to preheat,then stir it uniformly,
weigh it according to the given proportion,mix it and stir uniformly.

3.Using adhesive: Make the configured adhesive spread coating on the surface of adherend uniformly,gluing for double sides,
then fold it,knock it from the middle to all around for once with rubber hammer,avoid getting into the air in the middle,before
the adhesive doesn’t cure,be sure to compress the rubber and metal to be compacted.

4.Curing: Initial curing for 4 hours at the room temperature,and heat it up to the temperature of 80℃ and keep this temperature
for 3 hours,then do the last curing,can get the excellent adhesive property.

Packaging specification:
Two-component,12Kg/group,A component: 8Kg, B component: 4Kg,packed in a plastic drum.

Transportation storage:
This product is general chemicals,should pay attention to waterproof and fire prevention during transportation and storage,
save it in a cool and dry place,the storage period is 12 months.

Product packaging photo of BD805 high temperature abrasion wear resistant rubber metal epoxy bonding adhesives:

------分隔线----------------------------